HotlineEngraving machine control system operation steps
1: Return to the machine origin (the machine origin is returned in the operation in the menu bar)
2: Define the engraving origin (X-axis Y-axis is set to 0)
3: Tool setting (set Z axis 0 points)
4: Open and load (call out the file to be carved)
5: Simulation (simulation)
6: Adjust the feed rate (engraving speed) and adjust the spindle speed (engraving speed)
7: Start carving
First, the operation steps of the Weihong motion control system NcstudioTM V5.4.55
1. Power on reset
Open NcStudio and click on the menu. Operation → Return to machine origin → prompt reset, click all axes can also be reset separately
After reset is complete (after the machine stops moving)
Click to close
2: Uninstall and load the engraving file
3. Processing origin
When the tool tip is aligned with the lower left corner of the material, the working coordinates X, Y are cleared (programmed defined origin position)
4: Tool setting
Use manual Z-axis down movement to clear Z workpiece coordinates when the tool tip touches the material surface
5: Simulation, cancel simulation <shortcut F8>
(Simulation: Whether the file is viewed correctly in the processing track window, the processing file cannot exceed the green box in the software, and the simulation is canceled after correct)
6: Slow down the feed rate, open and adjust the spindle speed (Note: ensure the spindle cooling water circulation is normal)
7: Click the Start button (F9) to process;
Pause (F10)
Stop (F11)