Engraving machine control system operation steps

1: Return to the machine origin (the machine origin is returned in the operation in the menu bar)

2: Define the engraving origin (X-axis Y-axis is set to 0)

3: Tool setting (set Z axis 0 points)

4: Open and load (call out the file to be carved)

5: Simulation (simulation)

6: Adjust the feed rate (engraving speed) and adjust the spindle speed (engraving speed)

7: Start carving

First, the operation steps of the Weihong motion control system NcstudioTM V5.4.55

1. Power on reset

Open NcStudio and click on the menu. Operation → Return to machine origin → prompt reset, click all axes can also be reset separately

After reset is complete (after the machine stops moving)

Click to close

2: Uninstall and load the engraving file

3. Processing origin

When the tool tip is aligned with the lower left corner of the material, the working coordinates X, Y are cleared (programmed defined origin position)

4: Tool setting

Use manual Z-axis down movement to clear Z workpiece coordinates when the tool tip touches the material surface

5: Simulation, cancel simulation <shortcut F8>

(Simulation: Whether the file is viewed correctly in the processing track window, the processing file cannot exceed the green box in the software, and the simulation is canceled after correct)

6: Slow down the feed rate, open and adjust the spindle speed (Note: ensure the spindle cooling water circulation is normal)

7: Click the Start button (F9) to process;

Pause (F10)

Stop (F11)